Skip to Main Content Area. To remove the write protection: Hold down the Windows key and press the letter X. Select Command Prompt Admin. If it prompts for permission to open the program, select Yes. It's far from perfect, partly because today's advanced disk technology makes data-recovery more difficult than it was with the simpler technology of the past.
It comes with a selection of advanced features, including partition recovery, formatted drive restoration, and corrupted file repair.
Screen Recorder. Transfer Products. File Management. More Products. Workable Solutions Step-by-step Troubleshooting Fix 1. Connect the unlocked USB Full steps Fix 2. This will launch Command Prompt Full steps Fix 3. Full steps Fix 4. Edit Registry Connect your write-protected removable device to the PC. Open the Registry Editor by pressing Full steps Fix 5. Full steps. Image 1 - USB flash drive switch. Image 2 - SD card lock switch.
Was This Page Helpful? Read full bio. This method is applied to the situation that the attributes of your hard drive has been set as read-only in Diskpart. The steps are listed as follows:. Within a few seconds, Diskpart utility cleared Read-only successfully. When the value of Windows Registry Key is set incorrectly, you can remove write protection using Registry Editor.
Then name it with StorageDevicePolicies. Name it with Write Protect and open it to set the Value data to 0. If your disk write-protected error is caused by corrupted file system, you can remove write protection on hard drive via formatting.
Free download it and see how it works. And you should back up your data on the external hard drive before formatting as this operation will erase all data on it. Thus, if an external hard drive or internal drive volume becomes write-protected, you need to rely on Windows troubleshooting steps to remove the write-protection. But before you head to solutions, here are a few common reasons that enable write-protection on a hard drive:. A write-protected hard drive allows you to access the data in it if the drive is not corrupt , but you cannot write or paste new files and folders, which makes the drive literally unusable.
To make it usable, you must remove write protection from the hard drive. NOTE: If the drive is corrupt or inaccessible, skip to Step 5 and immediately use a data recovery software such as Stellar Data Recovery to get back data from the RAW drive and safeguard it from further damage. Before proceeding with any fix, we need to figure out if the affected hard drive is corrupt. Follow these steps to determine and fix the hard drive error:. Check if the drive is encrypted by using Bit locker or other third-party tools.
Decrypt the hard drive and remove write-protection by using the same tool that was used for encryption. Decrypting hard drive or turning off encryption may remove write protection, and then you may be able to access and transfer files between your system and the connected hard drive. Disconnect your hard drive and connect it again to check if write-protection is disabled.
If not, follow the next step. In case the drive is corrupt and inaccessible, use a data recovery software immediately as files cannot be read or written on the affected hard drive. Follow these steps to recover data from a corrupt and write-protected hard drive,.
After data is recovered, use DiskPart or Disk Management tool to format the disk. It helps protect the card from malware or virus infection and data loss. However, when it comes to a hard drive, things change, as there is no physical switch to toggle write-protection in hard drives. Thus, when a hard drive becomes write-protected, it most likely indicates a severe virus or malware infection and corruption.
0コメント